NETGEAR 7300 Series - Manual (Page 100)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-34 Switching Commands
202-10009-01_060204
Mode
Global Config
no snmptrap
This command deletes trap receivers for a community.
Format no snmptrap <name> <ipaddr>
Mode
Global Config
snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of
name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries
using the same IP address, the first entry is retained and processed. All duplicate entries are
ignored.
Format
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Mode Global Config
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format snmptrap mode <name> <ipaddr>
Mode
Global Config
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able to receive
traps).
Format
no snmptrap mode <name> <ipaddr>
Mode Global Config