NETGEAR 7300 Series - Manual (Page 199)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-17
202-10009-01_060204
The range of preference is 0 to 255.
Default Intra -- 8; Inter -- 10; Type-1 -- 13; Type-2 -- 150.
Format
distance ospf {intra | inter | type1 | type2} <0-255>
Mode Router OSPF Config
no distance ospf
This command sets the default route preference value of OSPF in the router. The type of OSPF can
be intra, inter, type-1, or type-2. Format
Format no distance ospf {intra | inter | type1 | type2}
Mode
Router OSPF Config
distance rip
This command sets the route preference value of RIP in the router. Lower route preference values
are preferred when determining the best route.
Default 15
Format distance rip <0-255>
Mode
Router RIP Config
no distance rip
This command sets the default route preference value of RIP in the router.
Format no distance rip
Mode
Router RIP Config
distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format distribute-list <1-199> out {rip | bgp | static | con-
nected}
Mode Router OSPF Config