NETGEAR 7300 Series - Manual (Page 157)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-91
202-10009-01_060204
disconnect
This command closes a telnet session.
Format disconnect {<sessionID> | all}
Mode
Privileged EXEC
show loginsession
This command displays current telnet and serial port connections to the switch.
Format show loginsession
Mode
Privileged EXEC
ID Login Session ID
User Name The name the user will use to login using the serial port or Telnet. A new user
may be added to the switch by entering a name in a blank entry. The user name may be up to 8
characters, and is not case sensitive. Two users are included as the factory default, admin and
guest.
Connection From IP address of the telnet client machine or EIA-232 for the serial
port connection.
Idle Time Time this session has been idle.
Session Time Total time this session has been connected.
show users
This command displays the configured user names and their settings. This command is only
available for users with readwrite privileges.
The SNMPv3 fields will only be displayed if SNMP is available
on the system.
Format
show users
Mode Privileged EXEC
User Name The name the user will use to login using the serial port, Telnet or
Web. A new user may be added to the switch by entering a name
in a blank entry. The user name may be up to eight characters, and
is not case sensitive. Two users are included as the factory
default, admin and guest