Show interface ethernet, Show interface ethernet -4 – NETGEAR 7300 Series User Manual
Page 70
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-4
Switching Commands
202-10009-01_060204
Packets Received Without Error The total number of packets (including broadcast pack-
ets and multicast packets) received by the processor.
Broadcast Packets Received The total number of packets received that were directed to
the broadcast address. Note that this does not include multicast
packets.
Packets Received With Error The number of inbound packets that contained errors pre-
venting them from being deliverable to a higher-layer protocol.
Packets Transmitted Without Error The total number of packets transmitted out of the
interface.
Broadcast Packets Transmitted The total number of packets that higher-level protocols
requested to be transmitted to the Broadcast address, including
those that were discarded or not sent.
Transmit Packet Errors The number of outbound packets that could not be transmitted
because of errors.
Address Entries Currently In Use The total number of Forwarding Database Address
Table entries now active on the switch, including learned and
static entries.
VLAN Entries Currently In Use The number of VLAN entries presently occupying the
VLAN table.
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-
onds since the statistics for this switch were last cleared.
show interface ethernet
This command displays detailed statistics for a specific port or for all CPU traffic based upon the
argument.
Format
show interface ethernet {<slot/port> | switchport}
Mode
Privileged EXEC
The display parameters when the argument is ' <slot/port>' is as follows:
Packets Received
Octets Received - The total number of octets of data (including
those in bad packets) received on the network (excluding framing
bits but including FCS octets). This object can be used as a rea-
sonable estimate of ethernet utilization. If greater precision is
desired, the etherStatsPkts and etherStatsOctets objects should be
sampled before and after a common interval. ----- The result of