NETGEAR 7300 Series - Manual (Page 226)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-44 Routing Commands
202-10009-01_060204
OSPF Area ID Represents the OSPF Area Id for the specified interface. This is a
configured value.
Router Priority A number representing the OSPF Priority for the specified inter-
face. This is a configured value.
Hello Interval A number representing the OSPF Hello Interval for the specified
interface. This is a configured value.
Dead Interval A number representing the OSPF Dead Interval for the specified
interface. This is a configured value.
Retransmit Interval A number representing the OSPF Retransmit Interval for the
specified interface. This is a configured value.
Transit Delay Interval A number representing the OSPF Transit Delay for the specified
interface. This is a configured value.
LSA Ack Interval A number representing the OSPF LSA Acknowledgement Inter-
val for the specified interface.
show ip ospf interface stats
This command displays the statistics for a specific interface. The information below will only be
displayed if OSPF is enabled.
Format
show ip ospf interface stats <slot/port>
Mode Privileged EXEC and User EXEC
OSPF Area ID The area id of this OSPF interface.
Spf Runs The number of times that the intra-area route table has been cal-
culated using this area's link-state database.
Area Border Router Count The total number of area border routers reachable within this
area. This is initially zero, and is calculated in each SPF pass.
AS Border Router Count The total number of Autonomous System border routers reach-
able within this area.
Area LSA Count The total number of link-state advertisements in this area's link-
state database, excluding AS External LSAs.
IP Address The IP address associated with this OSPF interface.
OSPF Interface Events The number of times the specified OSPF interface has changed
its state, or an error has occurred.
Virtual Events The number of state changes or errors that occurred on this virtual
link.