Dot1x re-authenticate, Dot1x re-authentication, No dot1x re-authentication – NETGEAR 7300 Series User Manual
Page 165: Dot1x system-auth-control, No dot1x system-auth-control, Dot1x re-authenticate -99, Dot1x re-authentication -99, No dot1x re-authentication -99, Dot1x system-auth-control -99, No dot1x system-auth-control -99
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands
8-99
202-10009-01_060204
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error
will be returned.
Format
dot1x re-authenticate <slot/port>
Mode
Privileged EXEC
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default
Disabled
Format
dot1x re-authentication
Mode
Interface
Config
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
no dot1x re-authentication
Mode
Interface Config
dot1x system-auth-control
This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
Default
Disabled
Format
dot1x system-auth-control
Mode
Global Config
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format
no dot1x system-auth-control