NETGEAR 7300 Series - Manual (Page 87)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-21
202-10009-01_060204
Mode
Privileged EXEC
network protocol
This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately.
Default
None
Format network protocol {none | bootp | dhcp}, where bootp
indicates that the switch periodically sends requests to a Boot-
strap Protocol (BootP) server or a dhcp server until a response is
received.
none indicates that the switch should be manually con-
figured with IP information.
Mode
Privileged EXEC
remotecon maxsessions
This command specifies the maximum number of remote connection sessions that can be
established. A value of 0 indicates that no remote connection can be established. The range is 0 to
5.
Default 5
Format remotecon maxsessions <0-5>
Mode
Privileged EXEC
no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to
the default value.
Default 5
Format no remotecon maxsessions
Mode
Privileged EXEC