NETGEAR 7300 Series - Manual (Page 35)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Administration Console Telnet Interface 3-3
202-10009-01_060204
4. When the following screen appears, make sure that the port setting are as follows:
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Figure 3-4: Connection Settings
5. Click OK.
The HyperTerminal window will open and you should be connected to the switch. If you do not
get a welcome screen or a system menu, press the return key.
When attached to the User Interface via a Telnet Session, the following must be set in order to use
the arrow keys: Under the terminal pull down menu, choose Properties and make sure the VT100
Arrows option is turned on.