NETGEAR 7300 Series - Manual (Page 178)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-112 Switching Commands
202-10009-01_060204
802.1x Port Security This field displays the authentication login list assigned to the
user for 802.1x port security.
users defaultlogin
This command assigns the authentication login list to use for non-configured users when
attempting to log in to the system. This setting is overridden by the authentication login list
assigned to a specific user if the user is configured locally. If this value is not configured, users will
be authenticated using local authentication only.
Format users defaultlogin <listname>
Mode
Global Config
users login
This command assigns the specified authentication login list to the specified user for system login.
The <
user> must be a configured < user> and the < listname> must be a configured login list.
If the user is assigned a login list that requires remote authentication, all access to the interface
from all CLI, web, and telnet sessions will be blocked until the authentication is complete.
Note that the login list associated with the ‘admin’ user can not be changed to prevent accidental
lockout from the switch.
Format
users login <user> <listname>
Mode
Global Config
System Utilities
This section describes system utilities.
clear config
This command resets the configuration to the factory defaults without powering off the switch.
The switch is automatically reset when this command is processed. You are prompted to confirm
that the reset should proceed.
Format
clear config