NETGEAR 7300 Series User Manual

Page 64

Advertising
background image

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

7-6

Mode-based CLI

202-10009-01_060204

the router interface configuration commands. The command
prompt at this level is:

Command Prompt: $(Interface <slot/port>)#

The resulting prompt for the interface configuration command
entered in the Global Configuration mode is shown below:

$(Config)# interface 2/1

$(Interface 2/1)#

Line Config Mode

This mode allows the operator to configure the console interface.
The operator may configure the interface from the directly con-
nected console or the virtual terminal used with Telnet. The com-
mand prompt at this level is:

Command Prompt: $(Line)#

Policy Map Mode

Use the policy-map command to access the QoS policy map con-
figuration mode to configure the QoS policy map.

$(Config)# policy-map

Command Prompt: $(Config policy-map)#

Policy Class Mode

Use the "class" command to access the QoS policy- classmap
mode to configure the QoS policy map.

$(Config-policy-map)# class

Command Prompt: $(Config - policy-classmap)#

Class Map Mode

This mode consists of class creation/deletion and matching com-
mands. The class match commands specify layer 2, layer 3 and
general match criteria. Use the class-map commands to access the
QoS class map configuration mode to configure QoS class maps.

$(Config)# class map

Command Prompt: $(Config - class)#

Router Config OSPF Mode

In this mode, the operator is allowed to access the router OSPF
configuration commands. The command prompt at this level is:

$(Config)# router ospf

Command Prompt: $(Config-router)#

Router Config RIP Mode

In this mode, the operator is allowed to access the router RIP con-
figuration commands. The command prompt at this level is:

$(Config)# router rip

Command Prompt: $(Config-router)#

DHCP Pool Configuration Mode

Use the ip dhcp pool <pool-name> command to access the

DHCP Pool Config Mode.

Advertising