NETGEAR 7300 Series - Manual (Page 233)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-51
202-10009-01_060204
show ip route entry
This command displays detailed information about the route to a specific network to be displayed.
The value for <networkaddr> is a valid IP address.
Format show ip route entry <networkaddr>
Mode
Privileged EXEC and User EXEC
Network Address Is a valid network address identifying the network on the speci-
fied interface.
Subnet Mask Is a mask of the network and host portion of the IP address for the
attached network.
Protocol Tells which protocol added the specified route. The possibilities
are: local, static, OSPF or RIP.
Next Hop Interface The outgoing router interface to use when forwarding traffic to
the next destination.
Next Hop IP Address The outgoing router IP address to use when forwarding traffic to
the next router (if any) in the path toward the destination.
Metric The metric value that is used for this route entry.
show ip route preferences
This command displays detailed information about the route preferences. Route preferences are
used in determining the best route. Lower router preference values are preferred over higher router
preference values.
Format
show ip route preferences
Mode Privileged EXEC and User EXEC
Local This field displays the local route preference value.
Static This field displays the static route preference value.
OSPF Intra This field displays the OSPF Intra route preference value.
OSPF Inter This field displays the OSPF Inter route preference value.
OSPF Type-1 This field displays the OSPF Type-1 route preference value.
OSPF Type-2 This field displays the OSPF Type-2 route preference value.
RIP This field displays the RIP route preference value.
BGP4 This field displays the BGP-4 route preference value.