Redistribute (rip), No redistribute (rip), Router-id – NETGEAR 7300 Series User Manual
Page 216: Routing, Redistribute (rip) -34, No redistribute (rip) -34, Router-id -34, Routing -34
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-34
Routing Commands
202-10009-01_060204
redistribute (RIP)
This command configures RIP protocol to redistribute routes from the specified source protocol/
routers.
Default value for metric not-configured
Default value for match internal
Format for OSPF as source protocol
redistribute ospf [metric <0-15>] [match [internal]
[external 1] [external 2] [nssa-external 1] [nssa-
external-2]]
Format for other source protocol
redistribute {bgp | static | connected} [metric <0-
15>]
Mode
Router RIP Config
no redistribute (RIP)
This command de-configures RIP protocol to redistribute routes from the specified source
protocol/routers.
Format
no redistribute {ospf | bgp | static | connected}
[metric] [match [internal] [external 1] [external 2]
[nssa-external 1] [nssa-external-2]]
Mode
Router RIP Config
router-id
This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id. The
<ipaddress> is a configured value.
Format
router-id <ipaddress>
Mode
Router OSPF Config
routing
This command enables routing for an interface.