Ip rip receive version, No ip rip receive version, Ip rip send version – NETGEAR 7300 Series User Manual
Page 212: No ip rip send version, Ip rip receive version -30, No ip rip receive version -30, Ip rip send version -30, No ip rip send version -30
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-30
Routing Commands
202-10009-01_060204
ip rip receive version
This command configures the interface to allow RIP control packets of the specified version(s) to
be received.
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP
version 2, both to receive packets from either format, or none to not allow any RIP control packets
to be received.
Default
both
Format
ip rip receive version {rip1 | rip2 | both | none}
Mode
Interface Config
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be
received.
Format
no ip rip receive version
Mode
Interface Config
ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be
sent.
The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP
version 1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for
sending RIP version 2 using multicast, or none to not allow any RIP control packets to be sent.
Default
rip1c
Format
ip rip send version {rip1 | rip1c | rip2 | none}
Mode
Interface Config
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be
sent.
Format
no ip rip send version
Mode
Interface Config