NETGEAR 7300 Series - Manual (Page 192)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-10 Routing Commands
202-10009-01_060204
no arp dynamicrenew
This command disables ARP component from automatically renewing ARP entries of type
dynamic when they age out.
Format
no arp dynamicrenew
Mode Privileged Exec
arp purge
This command causes the specified IP address to be removed from the ARP cache. Only entries of
type dynamic or gateway are affected by this command.
Format
arp purge <ipaddr>
Mode Privileged EXEC
arp resptime
This command configures the ARP request response timeout.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry response
timeout time in seconds. The range for <seconds> is between 1-10 seconds.
Default l
Format
arp resptime <1-10>
Mode Global Config
no arp resptime
This command configures the default ARP request response timeout.
Format
no arp resptime
Mode Global Config
arp retries
This command configures the ARP count of maximum request for retries.
The value for <retries> is an integer, which represents the maximum number of request for retries.
The range for <retries> is an integer between 0-10 retries.