Match dstip, Match dstl4port, Match dstip -7 – NETGEAR 7300 Series User Manual

Page 249: Match dstl4port -7

Advertising
background image

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

CLI Commands: Differentiated Services

10-7

202-10009-01_060204

Default

None

Format

match [not] destination-address mac <macaddr> <mac-

mask>

Mode

Class-Map Config

match dstip

This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The <ipaddr>

parameter specifies an IP address. The <

ipmask>

parameter

specifies an IP address bit mask; note that although similar to a standard subnet mask, this bit mask
need not be contiguous. The optional [

not]

parameter has the effect of negating this match

condition for the class (i.e., match all destination IP addresses except for what is specified here).

Default

None

Format

match [not] dstip <ipaddr> <ipmask>

Mode

Class-Map Config

match dstl4port

This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword or numeric notation or a numeric range notation.

To specify the match condition as a single keyword, the value for <

portkey>

is one of the supported

port name keywords. The currently supported <

portkey>

values are:

domain, echo, ftp, ftpdata, http,

smtp, snmp, telnet, tftp, www

. Each of these translates into its equivalent port number, which is used as

both the start and end of a port range.

To specify the match condition using a numeric notation, one layer 4 port number is required. The
port number is an integer from 0 to 65535.

To specify the match condition using a numeric range notation, two layer 4 port numbers are
required and together they specify a contiguous port range. Each port number is an integer from 0
to 65535, but with the added requirement that the second number be equal to or greater than the
first.

The optional [not] parameter has the effect of negating this match condition for the class (i.e.,
match all destination layer 4 port numbers except for the one specified here).

Default

None

Advertising