NETGEAR 7300 Series - Manual (Page 275)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
DHCP Server Commands 12-3
202-10009-01_060204
hardware-address
This command specifies the hardware address of a DHCP client.
Hardware-address is the MAC address of the hardware platform of the client consisting of 6 bytes
in dotted hexadecimal format.
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Default Ethernet
Format hardware-address <hardwareaddress> [type]
Mode DHCP Pool Config Mode
no hardware-address
This command removes the hardware address of the DHCP client.
Format no hardware-address
Mode DHCP Pool Config Mode
host
This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
The prefix-length is an integer from 0 to 32
Default None
Format host <address> [mask | prefix-length]
Mode DHCP Pool Config Mode
no host
This command removes the IP address of the DHCP client.
Format no host
Mode DHCP Pool Config Mode