NETGEAR 7300 Series - Manual (Page 186)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-4 Routing Commands
202-10009-01_060204
area nssa translator-stab-intv
This command configures the translator stability interval of the NSSA. The stabilityinterval is the
period of time that an elected translator continues to perform its duties after it determines that its
translator status has been deposed by another router.
Format
area <areaid> nssa translator-stab-intv <stability-
interval>
Mode Router OSPF Config
area range
This command creates a specified area range for a specified NSSA. The <ipaddr> is a valid IP
address. The <subnetmask> is a valid subnet mask. The lsdb type must be specified by either
summarylink or nssaexternallink, and the advertising of the area range can be optionally allowed
or suppressed.
Format
area <areaid> range <ipaddr> <subnetmask> {summa-
rylink | nssaexternallink} [advertise/not-advertise]
Mode Router OSPF Config
no area range
This command deletes a specified area range.
The <ipaddr> is a valid IP address.
The <subnetmask> is a valid subnet mask.
Format
no area <areaid> range <ipaddr> <subnetmask>
Mode Router OSPF Config
area stub
This command creates a stub area for the specified area ID. A stub area is characterized by the fact
that AS External LSAs are not propagated into the area. Removing AS External LSAs and
Summary LSAs can significantly reduce the link state database of routers within the stub area.
Format area <areaid> stub
Mode
Router OSPF Config