NETGEAR 7300 Series - Manual (Page 309)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
IS CLI Mapping A-21
202-10009-01_060204
Routing config router vrrp interface
authdetails <slot/port> <vrID>
<none | simple> [key] Interface
Config ip vrrp <VrID> authentication [<key>]
Interface
Config
no ip vrrp <VrID> authentication
Routing config router vrrp removedetails
<slot/port> <vrID> Interface
Config ip vrrp removedetails <VrID>
Routing config router rtrdiscovery
adminmode <slot/port> <enable |
disable> Interface
Config ip irdp [{holdtime <maxinterval-9000>
| maxadvertinterval <4-1800> |
minadvertinterval <3-maxinterval> |
preference <-2147483648 -
2147483647> | address <address>}]
Interface
Config
no ip irdp
Routing config router rtrdiscovery
maxinterval <slot/port> <4-1800>
Routing config router rtrdiscovery
mininterval <slot/port>
<3-maxinterval>
Routing config router rtrdiscovery lifetime
<slot/port> <max-interval-9000>
Routing config router rtrdisocvery address
<slot/port> <ipaddr>
Routing config router rtrdisocvery prefrence
<slot/port> <-2147483648 -
2147483647>
Routing config router bootpdhcprelay
cidoptmode <enable | disable> Global
Config bootpdhcprelay cidoptmode
Global
Config
no bootpdhcprelay cidoptmode
Routing config router bootpdhcprelay
adminmode <enable/disable> Global
Config bootpdhcprelay disable
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax