NETGEAR 7300 Series - Manual (Page 306)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
A-18 IS CLI Mapping
202-10009-01_060204
Interface
Config
no ip rip authentication
Routing config router rip interface
defaultmetric <slot/port> <0-15> Router
RIP
Config default-information originate
Routing config router rip interface mode
<enable | disable> Interface
Config ip rip
Interface
Config
no ip rip
Routing config router rip interface version
receive <slot/port> <rip1 | rip2 |
both | none> Interface
Config ip rip receive version {rip1 | rip2 | both
| none}
Interface
Config
no ip rip receive version
Routing config router rip interface version
send <slot/port> <rip1 | rip1c | rip2 |
none> Interface
Config ip rip send version {rip1 | rip1c | rip2 |
none}
Interface
Config
no ip rip send version
Routing config router ospf virtif create
<areaid> <neighbor> Router
OSPF
Config area <areaid> virtual-link
<neighborid> [authentication [none |
{simple <key>} | {encrypt <key>
<keyid>}]] [hello-interval <1-65535>]
[retransmit-interval <0-3600>]
[transmit-delay <0-3600>]
[dead-interval <1-65535>]
Routing config router ospf virtif interval
transdelay <areaid> <neighbor>
<0-3600>
Routing config router ospf virtif
authentication <areaid>
<neighbor> <none | simple> [key]
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax