Storm-control broadcast, No storm-control broadcast, Storm-control broadcast -69 – NETGEAR 7300 Series User Manual
Page 135: No storm-control broadcast -69
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands
8-69
202-10009-01_060204
Mode
Global Config
Acceptable values are:
100h
100BASE-T half-duplex
100f
100BASE-T full duplex
10h
10BASE-T half duplex
10f
100BASE-T full duplex
storm-control broadcast
This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in “Broadcast Storm Recovery
Thresholds” table) of the link speed, the switch discards the broadcasts traffic until the broadcast
traffic returns to the low threshold percentage or less. The full implementation is depicted in the
“Broadcast Storm Recovery Thresholds” table.
Format
switchconfig storm-control broadcast
Mode
Global Covnfig
no storm-control broadcast
This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in “Broadcast Storm Recovery
Thresholds” table) of the link speed, the switch discards the broadcasts traffic until the broadcast
traffic returns to the low threshold percentage or less. The full implementation is depicted in the
“Broadcast Storm Recovery Thresholds” table.
Table 8-1.
Broadcast Storm Recovery Thresholds
Link Speed
High
Low
10M
20
10
100M
5
2
1000M
5
2