Ip ospf hello-interval, No ip ospf hello-interval, Ip ospf priority – NETGEAR 7300 Series User Manual
Page 209: No ip ospf priority, Ip ospf hello-interval -27, No ip ospf hello-interval -27, Ip ospf priority -27, No ip ospf priority -27
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands
9-27
202-10009-01_060204
ip ospf hello-interval
This command sets the OSPF hello interval for the specified interface.
The value for <seconds> is a valid positive integer, which represents the length of time in seconds.
The value for the length of time must be the same for all routers attached to a network.
Valid values range from 1 to 65535.
Default
10
Format
ip ospf hello-interval <1-65535>
Mode
Interface Config
no ip ospf hello-interval
This command sets the default OSPF hello interval for the specified interface.
Format
no ip ospf hello-interval
Mode
Interface Config
ip ospf priority
This command sets the OSPF priority for the specified router interface. The priority of the
interface is a priority integer from 0 to 255.
A value of '0' indicates that the router is not eligible to become the designated router on this
network.
Default
1, which is the highest router priority.
Format
ip ospf priority <0-255>
Mode
Interface Config
no ip ospf priority
This command sets thedefault OSPF priority for the specified router interface.
Format
no ip ospf priority
Mode
Interface Config