NETGEAR 7300 Series - Manual (Page 150)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-84 Switching Commands
202-10009-01_060204
Default The base MAC address displayed using hexadecimal notation as
specified in IEEE 802 standard.
Format spanning-tree configuration name <name>
Mode Global Config
no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
Format no spanning-tree configuration name
Mode Global Config
spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is a
number in the range of 0 to 65535.
Default 0
Format spanning-tree configuration revision <0-65535>
Mode Global Config
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value, i.e. 0.
Format no spanning-tree configuration revision
Mode Global Config
spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal spanning
tree. This will allow this port to transition to Forwarding State without delay.
Format spanning-tree edgeport
Mode Interface Config