Bootpdhcprelay serverip, No bootpdhcprelay serverip, Clear arp-cache – NETGEAR 7300 Series User Manual
Page 196: Default-information originate (ospf), No default-information originate (ospf), Bootpdhcprelay serverip -14, No bootpdhcprelay serverip -14, Clear arp-cache -14, Default-information originate (ospf) -14, No default-information originate (ospf) -14
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-14
Routing Commands
202-10009-01_060204
bootpdhcprelay serverip
This command configures the server IP Address for BootP/DHCP Relay on the system. The
<ipaddr> parameter is an IP address in a 4-digit dotted decimal format.
Default
0.0.0.0
Format
bootpdhcprelay serverip <ipaddr>
Mode
Global Config
no bootpdhcprelay serverip
This command configures the default server IP Address for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay serverip
Mode
Global Config
clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the
gateway parameter is specified, the dynamic entries of type gateway are purged as well.
Format
clear arp-cache [gateway]
Mode
Privileged Exec
default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Default value for metric unspecified
Default value for type 2
Format
default-information originate [always] [metric <0-
16777215>] [metric-type {1 | 2}]
Mode
Router OSPF Config
no default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Format
no default-information originate [metric] [metric-
type]