NETGEAR 7300 Series - Manual (Page 278)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
12-6 DHCP Server Commands
202-10009-01_060204
network
This command is used to configure the subnet number and mask for a DHCP address pool on the
server. Network-number is a valid IP address, made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address pool. The
prefix-length is an integer from 0 to 32.
Default None
Format network <networknumber> [mask | prefixlength]
Mode DHCP Pool Config
no network
This command removes the subnet number and mask.
Format no network
Mode DHCP Pool Config
service dhcp
This command enables the DHCP server and relay agent features on the router.
Default Disabled
Format service dhcp
Mode Global Config
no service dhcp
This command disables the DHCP server and relay agent features.
Format no service dhcp
Mode Global Config
DHCP Server Show Commands
These commands display the DHCP Server address bindings, and statistics.