NETGEAR 7300 Series - Manual (Page 229)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-47
202-10009-01_060204
Format
show ip ospf range <areaid>
Mode Privileged EXEC and User EXEC
Area ID Is the area id of the requested OSPF area.
IP Address Is an IP Address which represents this area range.
Subnet Mask Is a valid subnet mask for this area range.
Lsdb Type Is the type of link advertisement associated with this area range.
Advertisement This indicates whether the advertisement status is enabled or dis-
abled.
show ip ospf stub table
This command displays the OSPF stub table. The information below will only be displayed if
OSPF is initialized on the switch.
Format
show ip ospf stub table
Mode Privileged EXEC and User EXEC
Area ID Is a 32-bit identifier for the created stub area.
Type of Service Is the type of service associated with the stub metric. The 7300
Series L3 Switch only supports Normal TOS.
Metric Val The metric value is applied based on the TOS. It defaults to the
least metric of the type of service among the interfaces to other
areas. The OSPF cost for a route is a function of the metric value.
Metric Type Is the type of metric advertised as the default route.
Import Summary LSA Controls the import of summary LSAs into stub areas.
show ip ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor.
The <areaid> parameter identifies the area and the <neighbor> parameter identifies the neighbor's
IP Address.
Format
show ip ospf virtual-link <areaid> <neighbor>
Mode Privileged EXEC and User EXEC
Area ID Is the area id of the requested OSPF area.
Neighbor IP Address Is the neighbor IP Address that is entered.