NETGEAR 7300 Series - Manual (Page 217)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-35
202-10009-01_060204
The current value for this function is displayed under "show ip interface" labeled as "Routing
Mode".
Default Disabled
Format routing
Mode
Interface Config
no routing
This command disables routing for an interface.
The current value for this function is displayed under "show ip interface" labeled as "Routing
Mode".
Format no routing
Mode
Interface Config
show arp
This command displays the Address Resolution Protocol (ARP) cache. The displayed results are
not the total ARP entries. To view the total ARP entries, the operator should view the
show arp
results in conjunction with the show arp switch results.
Format show arp
Mode
Privileged EXEC
Age Time (seconds) Is the time it takes for an ARP entry to age out. This value was
configured into the unit. Age time is measured in seconds.
Response Time (seconds) Is the time it takes for an ARP request timeout. This value
was configured into the unit. Response time is measured in sec-
onds.
Retries Is the maximum number of times an ARP request is retried. This
value was configured into the unit.
Cache Size Is the maximum number of entries in the ARP table. This value
was configured into the unit.
Dynamic Renew Mode Displays whether the ARP component automatically attempts to
renew dynamic ARP entries when they age out.
Total Entry Count Current / Peak Field listing the total entries in the ARP table and the
peak entry count in the ARP table.