NETGEAR 7300 Series - Manual (Page 69)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-3
202-10009-01_060204
Burned in MAC Address Universally assigned network address.
Software Version The release.version.revision number of the code currently run-
ning on the switch.
Operating System The operating system currently running on the switch.
Network Processing Element The type of the processor microcode.
Additional Packages This displays the additional packages that are incorporated into
this system, such as 7300 Series L3 Switch BGP-4, or 7300
Series L3 Switch Multicast.
show interface
This command displays a summary of statistics for a specific port or a count of all CPU traffic
based upon the argument.
Format show interface {<slot/port> | switchport}
Mode
Privileged EXEC
The display parameters when the argument is ' <slot/port>' is as follows:
Packets Received Without Error The total number of packets (including broadcast pack-
ets and multicast packets) received by the processor.
Packets Received With Error The number of inbound packets that contained errors pre-
venting them from being deliverable to a higher-layer protocol.
Broadcast Packets Received The total number of packets received that were directed to
the broadcast address. Note that this does not include multicast
packets.
Packets Transmitted Without Error The total number of packets transmitted out of the
interface.
Transmit Packets Errors The number of outbound packets that could not be transmitted
because of errors.
Collisions Frames The best estimate of the total number of collisions on this Ether-
net segment.
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-
onds since the statistics for this port were last cleared.
The display parameters when the argument is 'switchport' is as follows: