NETGEAR 7300 Series - Manual (Page 160)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-94 Switching Commands
202-10009-01_060204
users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The
valid authentication protocols are
none , md5 or sha . If md5 or sha are specified, the user login
password will be used as the snmpv3 authentication password. The < username> is the login user
name for which the specified authentication protocol will be used.
Default no authentication
Format
users snmpv3 authentication <username> {none | md5 |
sha}
Mode Global Config
no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified login user to none. The
<username> is the login user name for which the specified authentication protocol will be used.
Format users snmpv3 authentication <username>
Mode Global Config
users snmpv3 encryption
This command specifies the encryption protocol and key to be used for the specified login user.
The valid encryption protocols are
none or des . The des protocol requires a key , which can be
specified on the command line. The key may be up to 16 characters long. If the des protocol is
specified but a key is not provided, the user will be prompted for the key. If none is specified, a key
must not be provided. The < username> is the login user name for which the specified encryption
protocol will be used.
Default no encryption
Format users snmpv3 encryption <username> {none | des [key]}
Mode Global Config
no users snmpv3 encryption
This command sets the encryption protocol to none. The <username> is the login user name for
which the specified encryption protocol will be used.
Format no users snmpv3 encryption <username>
Mode Global Config