NETGEAR 7300 Series - Manual (Page 101)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-35
202-10009-01_060204
telnet
This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be
established until there are no more sessions available. If sessions are disabled, no new telnet
sessions are established. An established session remains active until the session is ended or an
abnormal network error ends it.
Default
Enabled
Format telnet
Mode
Privileged EXEC
no telnet
This command disables telnet sessions. If sessions are disabled, no new telnet sessions are
established.
Format
no telnet
Mode Privileged EXEC
HTTP Commands
ip http secure-port
This command is used to set the sslt port where port can be 1-65535 and the default is port 443.
Default 443
Format
ip http secure-port <portid>
Mode Privileged EXEC
no ip http secure-port
This command is used to reset the sslt port to the default value.
Format
no ip http secure-port
Mode Privileged EXEC