3Com Wireless LAN WX1200 - Manual (Page 173)

set ntp 173
„
display ip https on page 145
„
display ip telnet on page 148
„
set ip https server on page 167
„
set ip telnet on page 171
set ntp Enables or disables the NTP client on a wireless LAN switch.
Syntax — set ntp {enable | disable}
„
enable — Enables the NTP client.
„
disable — Disables the NTP client.
Defaults — The NTP client is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If NTP is configured on a system whose current time differs
from the NTP server time by more than 10 minutes, convergence of the
WX time can take many NTP update intervals. 3Com recommends that
you set the time manually to the NTP server time before enabling NTP to
avoid a significant delay in convergence.
Examples — The following command enables the NTP client:
WX4400# set ntp enable
success: NTP Client enabled
See Also
„
clear ntp server on page 131
„
clear ntp update-interval on page 132
„
display ntp on page 149
„
set ntp server on page 174
„
set ntp update-interval on page 175