3Com Wireless LAN WX1200 - Manual (Page 289)

clear service-profile 289
Examples — The following commands disable the radios that are using
radio profile rp1 and reset the beaconed-interval parameter to its
default value:
WX4400# set radio-profile rp1 mode disable
WX4400# clear radio-profile rp1 beacon-interval
success: change accepted.
The following commands disable the radios that are using radio profile
rptest and remove the profile:
WX4400# set radio-profile rptest mode disable
WX4400# clear radio-profile rptest
success: change accepted.
See Also
„
display radio-profile on page 317
„
set {ap | dap} radio radio-profile on page 343
„
set radio-profile mode on page 362
clear service-profile Removes a service profile or resets one of the profile’s parameters to its
default value.
Syntax — clear service-profile name
„
name — Service profile name.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If the service profile is mapped to a radio profile, you must
remove it from the radio profile first. (After disabling all radios that use
the radio profile, use the clear radio-profile name service-profile name
command.)