3Com Wireless LAN WX1200 - Manual (Page 552)

552 C HAPTER 19: RF D ETECTION C OMMANDS
display rfdetect
visible Displays the BSSIDs discovered by a specific 3Com radio. The data
includes BSSIDs transmitted by other 3Com radios as well as by
third-party access points.
Syntax — display rfdetect visible mac-addr
Syntax — display rfdetect visible ap map-num [radio {1 | 2}]
Syntax — display rfdetect visible dap
dap-num [radio {1 | 2}]
„
mac-addr — Base MAC address of the 3Com radio.
To display the base MAC address of a 3Com radio, use the
display {ap | dap} status command.
„
map-num — Port connected to the MAP access point for which to
display neighboring BSSIDs.
„
dap-num — Number of a Distributed MAP for which to display
neighboring BSSIDs.
„
radio 1 — Shows neighbor information for radio 1.
„
radio 2 — Shows neighbor information for radio 2. (This option does
not apply to single-radio models.)
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If a 3Com radio is supporting more than one SSID, each of the
corresponding BSSIDs is listed separately.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.
Examples — The following command displays the devices detected by
3Com radio 00:0b:0e:00:0a:6a:
WX1200# display rfdetect visible 00:0b:0e:00:0a:6a ap 3 radio 1
Total number of entries: 104
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
Transmit MAC Vendor Type Ch RSSI Flags SSID