3Com Wireless LAN WX1200 - Manual (Page 334)

334 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Examples — The following command changes the name of the MAP
access point on port 1 to techpubs:
WX1200# set ap 1 name techpubs
success: change accepted.
See Also
„
display {ap | dap} config on page 290
set {ap | dap} radio
antennatype Sets the model number for an external antenna.
Syntax — set {ap port-list | dap dap-num} radio {1|2} antennatype
{ANT1060 | ANT1120 | ANT1180 |
ANT5060 | ANT5120 | ANT5180 |
ANT-1360-OUT | ANT-5360-OUT |ANT-5120-OUT | internal}
„
ap port-list — List of ports connected to the MAP access points on
which to set the channel.
„
dap dap-num — Number of a Distributed MAP on which to set the
channel.
„
radio 1 — Radio 1 of the MAP.
„
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„
antennatype {ANT1060 | ANT1120 | ANT1180 | internal} —
802.11b/g external antenna models:
„
ANT1060 — 60° 802.11b/g antenna
„
ANT1120 — 120° 802.11b/g antenna
„
ANT1180 — 180° 802.11b/g antenna
„
internal — uses the internal antenna instead
„
antennatype {ANT5060 | ANT5120 | ANT5180 | internal} —
802.11a external antenna models:
„
ANT5060 — 60° 802.11a antenna
„
ANT5120 — 120° 802.11a antenna
„
ANT5180 — 180° 802.11a antenna
„
internal — uses the internal antenna instead