3Com Wireless LAN WX1200 - Manual (Page 490)

490 C HAPTER 16: RADIUS AND S ERVER G ROUP C OMMANDS
Examples — To remove the server group sg-77 type the following
command:
WX4400# clear server group sg-77
success: change accepted.
To disable load balancing in a server group shorebirds, type the following
command:
WX4400# set server group shorebirds load-balance disable
success: change accepted.
See Also
„
set server group on page 496
set radius Configures global defaults for RADIUS servers that do not explicitly set
these values themselves. By default, the WX switch automatically sets all
these values except the password (key).
Syntax — set radius {deadtime minutes | key string |
retransmit number | timeout seconds}
„
deadtime minutes — Number of minutes the WX switch waits after
declaring an unresponsive RADIUS server unavailable before retrying
the RADIUS server. You can specify from 0 to 1440 minutes.
„
key string — Password (shared secret key) used to authenticate to
the RADIUS server. You must provide the same password that is
defined on the RADIUS server. The password can be 1 to 32
characters long, with no spaces or tabs.
„
retransmit number — Number of transmission attempts the WX
switch makes before declaring an unresponsive RADIUS server
unavailable. You can specify from 1 to 100 retries.
„
timeout seconds — Number of seconds the WX switch waits for the
RADIUS server to respond before retransmitting. You can specify from
1 to 65,535.
Defaults — Global RADIUS parameters have the following default
values:
„
deadtime — 0 (zero) minutes (The WX switch does not designate
unresponsive RADIUS servers as unavailable.)
„
key — No key