3Com Wireless LAN WX1200 - Manual (Page 509)

set dot1x bonded-period 509
Defaults — By default, authentication control for individual wired
authentication is enabled.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command applies only to wired authentication ports.
Examples — To enable per-port 802.1X authentication on wired
authentication ports, type the following command:
WX4400# set dot1x authcontrol enable
success: dot1x authcontrol enabled.
See Also
„
display dot1x on page 505
„
set dot1x port-control on page 512
set dot1x
bonded-period Changes the Bonded Auth™ (bonded authentication) period, which is
the number of seconds MSS retains session information for an
authenticated machine while waiting for the 802.1X client on the
machine to start (re)authentication for the user.
You must set the bonded period to longer than 0 seconds to enable
bonded authentication.
Syntax — set dot1x bonded-period seconds
„
seconds — Number of seconds MSS retains session information for an
authenticated machine while waiting for a client to (re)authenticate
on the same machine. You can change the bonded authentication
period to a value from 1 to 300 seconds.
Defaults — The default bonded period is 0 seconds, which disables the
feature.
Access — Enabled.
History —Introduced in MSS Version 3.0.