3Com Wireless LAN WX1200 - Manual (Page 81)

reset port 81
reset port Resets a port by toggling its link state and Power over Ethernet (PoE)
state.
Syntax — reset port port-list
„
port-list — List of physical ports. MSS resets all the specified ports.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The reset command disables the port’s link and PoE (if
applicable) for at least 1 second, then reenables them. This behavior is
useful for forcing a MAP access point that is connected to two WX
switches to reboot over the link to the other switch.
Examples — The following command resets port 5:
WX1200# reset port 5
See Also
„
set port on page 83
set dap Configures a Distributed MAP for a MAP access point that is indirectly
connected to the WX switch through an intermediate Layer 2 or Layer 3
network.
Before configuring a Distributed MAP, you must use the set
system countrycode command to set the IEEE 802.11 country-specific
regulations on the WX switch. See “set system countrycode” on page 56.
For a MAP that is directly connected to the WX switch, use the set port
type ap command to configure a MAP access port.
Syntax — set dap dap-num serial-id serial-ID model
{ap2750 | ap3750| ap7250 | ap8250 | ap8750 | mp-52 | mp-241 |
mp-252 | mp-262 | mp-341 | mp-352 | mp-372 | mp-372-CN |
mp-37-JP | mp-620} [radiotype {11a | 11b | 11g}]