3Com Wireless LAN WX1200 - Manual (Page 371)

set service-profile attr 371
If you plan to use SVP or another non-WMM type of prioritization, you
must configure ACLs to tag the packets. (See the “Enabling Prioritization
for Legacy Voice over IP” section in the “Configuring and Managing
Security ACLs” chapter of the
Wireless LAN Switch and Controller
Configuration Guide .)
Examples — The following command disables WMM in radio profile
radprofsvp:
WX4400# set radio-profile radprofsvp wmm disable
success: change accepted.
See Also
„
set radio-profile mode on page 362
„
display radio-profile on page 317
set service-profile
attr Configures authorization attributes that are applied by default to users
accessing the SSID managed by the service profile. These SSID default
attributes are applied in addition to any supplied by the RADIUS server or
from the local database.
Syntax — set service-profile name attr attribute-name value
„
name — Service profile name.
„
attribute-name value — Name and value of an attribute you are
using to authorize SSID users for a particular service or session
characteristic. For a list of authorization attributes and values that you
can assign to network users, see Table 44 on page 249. All of the
attributes listed in Table 44 can be used with this command except
ssid.
Defaults — By default, a service profile does not have any authorization
attributes set.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — To change the value of a default attribute for a service profile,
use the set service-profile attr command and specify a new value.