3Com Wireless LAN WX1200 - Manual (Page 587)

set boot partition 587
set boot partition Specifies the boot partition in which to look for the system image file
following the next system reset, software reload, or power cycle.
Syntax — set boot partition {boot0 | boot1}
„
boot0 — Boot partition 0.
„
boot1 — Boot partition 1.
Defaults — By default, an WX switch uses the same boot partition for
the next software reload that was used to boot the currently running
image.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To determine the boot partition that was used to load the
currently running software image, use the dir command.
Examples — The following command sets the boot partition for the next
software reload to partition 1:
WX4400# set boot partition boot1
success: Boot partition set to boot1.
See Also
„
copy on page 567
„
dir on page 570
„
reset system on page 582