3Com Wireless LAN WX1200 - Manual (Page 355)

set radio-profile beacon-interval 355
set radio-profile
beacon-interval Changes the rate at which each MAP radio in a radio profile advertises its
service set identifier (SSID).
Syntax — set radio-profile name beacon-interval interval
„
name — Radio profile name.
„
interval — Number of milliseconds (ms) between beacons. You can
specify from 25 ms to 8191 ms.
Defaults — The beacon interval for MAP radios is 100 ms by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
Examples — The following command changes the beacon interval for
radio profile rp1 to 200 ms:
WX4400# set radio-profile rp1 beacon-interval 200
success: change accepted.
See Also
„
display radio-profile on page 317
„
set radio-profile mode on page 362
set radio-profile
countermeasures Enables or disables countermeasures on the MAP radios managed by a
radio profile. Countermeasures are packets sent by a radio to prevent
clients from being able to use rogue access points.
CAUTION: Countermeasures affect wireless service on a radio. When a
MAP radio is sending countermeasures, the radio is disabled for use by
network traffic, until the radio finishes sending the countermeasures.