3Com Wireless LAN WX1200 - Manual (Page 330)

330 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
set {ap | dap} blink Enables or disables LED blink mode on a MAP access point to make it
easy to identify.
When blink mode is enabled on an AP2750, the 11a LED blinks on and
off.
When blink mode is enabled on an AP7250, the Radio LED flashes red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on an AP8250, the Radio LED flashes red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on an AP8750, both Radio LEDs flash red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on other models (MP-xxx), the health and
radio LEDs alternately blink green and amber. By default, blink mode is
disabled.
Syntax — set {ap port-list | dap dap-num | auto}
blink {enable | disable}
„
ap port-list — List of ports connected to the MAP access points on
which to turn blink mode on or off.
„
dap dap-num — Number of a Distributed MAP on which to turn blink
mode on or off.
„
dap auto — Configures blink mode for the MAP configuration
profile. (See set dap auto on page 325.)
„
enable — Enables blink mode.
„
disable — Disables blink mode.
Defaults — LED blink mode is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.