3Com Wireless LAN WX1200 - Manual (Page 347)

set radio-profile 11g-only 347
Defaults — Automatic firmware upgrades of MAP access points are
enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.
Usage — When the feature is enabled on an WX port, a MAP access
point connected to that port upgrades its boot firmware to the latest
version stored on the WX switch while booting.
Examples — The following command disables automatic firmware
upgrades on the MAP access point connected to port 6:
WX1200# set ap 6 upgrade-firmware disable
See Also
„
display {ap | dap} config on page 290
set radio-profile
11g-only Configures each 802.11b/g radio in a radio profile to allow associations
with 802.11g clients only.
Syntax — set radio-profile name 11g-only {enable | disable}
„
name — Radio profile name.
„
enable — Configures radios to allow associations with 802.11g
clients only.
„
disable — Configures radios to allow associations with 802.11g
clients and 802.11b clients.
Defaults — The default setting is disable. 3Com 802.11b/g radios allow
associations with 802.11g and 802.11b clients by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.