3Com Wireless LAN WX1200 - Manual (Page 269)

set mobility-domain member 269
set
mobility-domain
member On the seed WX switch, adds a member to the list of Mobility Domain
members. If the current WX switch is not configured as a seed, this
command is rejected.
Syntax — set mobility-domain member ip-addr
„
ip-addr — IP address of the Mobility Domain member in dotted
decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command must be entered from the seed WX switch.
Examples — The following commands add three WX switches with the
IP addresses 192.168.1.8, 192.168.1.9, and 192.168.1.10 as members of
a Mobility Domain whose seed is the current WX switch:
WX4400# set mobility-domain member 192.168.1.8
success: change accepted.
WX4400# set mobility-domain member 192.168.1.9
success: change accepted.
WX4400# set mobility-domain member 192.168.1.10
success: change accepted.
See Also
„
clear mobility-domain member on page 266
„
display mobility-domain config on page 267
„
set mobility-domain mode seed domain-name on page 271