3Com Wireless LAN WX1200 - Manual (Page 288)

288 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
See Also
„
set {ap | dap} radio mode on page 341
„
set {ap | dap} radio radio-profile on page 343
„
set port type ap on page 91
clear radio-profile Removes a radio profile or resets one of the profile’s parameters to its
default value.
Syntax — clear radio-profile name [parameter]
„
name — Radio profile name.
„
parameter — Radio profile parameter:
„
beacon-interval
„
dtim-interval
„
frag-threshold
„
long-retry
„
max-rx-lifetime
„
max-tx-lifetime
„
preamble-length
„
rts-threshold
„
service-profile
„
short-retry
(For information about these parameters, see the set radio-profile
commands that use them.)
Defaults — If you reset an individual parameter, the parameter is
returned to the default value listed in Table 66 on page 362.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If you specify a parameter, the setting for the parameter is
reset to its default value. The settings of the other parameters are
unchanged and the radio profile remains in the configuration. If you do
not specify a parameter, the entire radio profile is deleted from the
configuration. All radios that use this profile must be disabled before you
can delete the profile.