3Com Wireless LAN WX1200 - Manual (Page 193)

set timedate 193
Examples — The following commands configure an IP interface on
VLAN taupe and configure the interface to be the system IP address:
WX4400# set interface taupe ip 10.10.20.20/24
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
WX4400# set system ip-address 10.10.20.20
success: change accepted.
See Also
„
clear system ip-address on page 136
„
display system on page 43
„
set interface on page 160
set timedate Sets the time of day and date on the wireless LAN switch.
Syntax — set timedate {date mmm dd yyyy [time hh:mm:ss]}
„
date mmm dd yyyy — System date:
„
mmm — month
„
dd — day
„
yyyy — year
„
time hh:mm:ss — System time, in hours, minutes, and seconds.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The day of week is automatically calculated from the day you set.
The time displayed by the CLI after you type the command might be slightly
later than the time you enter due to the interval between when you press
Enter and when the CLI reads and displays the new time and date.
Configure summertime before you set the time and date. Otherwise,
summertime’s adjustment of the time will make the time incorrect, if the
date is within the summertime period.