3Com Wireless LAN WX1200 - Manual (Page 82)

82 C HAPTER 4: P ORT C OMMANDS
„
dap-num — Number for the Distributed MAP. The range of valid
connection numbers depends on the WX switch model:
„
For a WX4400, you can specify a number from 1 to 256.
„
For a WX1200, you can specify a number from 1 to 30.
„
serial-id serial-ID — MAP access point serial ID. The serial ID is
listed on the MAP case. To show the serial ID using the CLI, use the
display version details command.
„
radiotype 11a | 11b| 11g — Radio type:
„
11a — 802.11a
„
11b — 802.11b
„
11g — 802.11g
This option applies only to single-radio models.
Defaults — The default values are the same as the defaults for the
set port type ap command.
Access — Enabled.
History — Introduced in MSS Version 3.0. New values for model option
added in Version 4.1:
„
AP3750
„
AP2750
„
mp-620
Examples — The following command configures Distributed MAP 1 for
MAP model AP2750 with serial-ID M9DE48B012F00:
WX4400# set dap 1 serial-id M9DE48B012F00 model ap2750
success: change accepted.
The following command removes Distributed MAP 1:
WX4400# clear dap 1
This will clear specified DAP devices.
Would you like to continue? (y/n) [n]y
See Also
„
clear dap on page 64