3Com Wireless LAN WX1200 - Manual (Page 615)

set log 615
„
Logging state (enabled or disabled)
To override the session defaults for an individual session, type the set
log command from within the session and use the current option.
„
trace — Sets log parameters for trace files.
„
severity severity-level — Logs events at a severity level greater
than or equal to the level specified. Specify one of the following:
„
emergency — The WX switch is unusable.
„
alert — Action must be taken immediately.
„
critical — You must resolve the critical conditions. If the
conditions are not resolved, the WX can reboot or shut down.
„
error — The WX is missing data or is unable to form a connection.
„
warning — A possible problem exists.
„
notice — Events that potentially can cause system problems have
occurred. These are logged for diagnostic purposes. No action is
required.
„
info — Informational messages only. No problem exists.
„
debug — Output from debugging.
„
local-facility facility-level — For messages sent to a syslog
server, maps all messages of the severity you specify to one of the
standard local log facilities defined in RFC 3164. You can specify one
of the following values:
„
0 — maps all messages to local0.
„
1 — maps all messages to local1.
„
2 — maps all messages to local2.
„
3 — maps all messages to local3.
„
4 — maps all messages to local4.
„
5 — maps all messages to local5.
„
6 — maps all messages to local6.
„
7 — maps all messages to local7.
If you do not specify a local facility, MSS sends the messages with their
default MSS facilities. For example, AAA messages are sent with
facility 4 and boot messages are sent with facility 20 by default.
„
enable — Enables messages to the specified target.
„
disable — Disables messages to the specified target.