Set radio-profile auto-tune power-interval – 3Com Wireless LAN WX1200 User Manual
Page 354
354
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
set radio-profile auto-tune power-backoff- timer on page 352
set radio-profile auto-tune power-interval on page 354
set radio-profile
auto-tune
power-interval
Sets the interval at which RF Auto-Tuning decides whether to change the
power level on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous
interval, and changes radio power levels if needed.
Syntax —
set radio-profile name auto-tune
power-interval seconds
name
— Radio profile name.
seconds
— Number of seconds MSS waits before changing radio
power levels to adjust to RF changes, if needed. You can specify from
1 to 65535 seconds.
Defaults — The default power tuning interval is 300 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — RF Auto-Tuning also can temporarily increase a radio’s power
level to preserve the minimum data rate for an associated client. In this
case, the radio reduces its power in 1 dBm increments until the power
returns to the expected level.
Examples — The following command sets the power interval for radios
in radio profile rp2 to 240 seconds:
WX4400# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
See Also
set {ap | dap} radio auto-tune max-power on page 335
set {ap | dap} radio auto-tune max- retransmissions on page 337
set radio-profile auto-tune power-backoff- timer on page 352