3Com Wireless LAN WX1200 - Manual (Page 314)

314 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
The following command displays connection information specifically for a
Distributed MAP with serial ID M9DE48B6EAD00:
WX1200# display dap connection serial-id M9DE48B6EAD00
Total number of entries: 1
DAP Serial Id
DAP IP Address WX IP Address
--- ----------- --------------- ---------------
9 M9DE48B6EAD00 10.10.4.88 10.9.9.11
Table 60 describes the fields in this display.
See Also
„
display {ap | dap} config on page 290
„
display dap global on page 314
„
display dap unconfigured on page 316
display dap global Displays connection information for Distributed MAPs configured on a
WX switch.
Syntax — display dap global [dap-num | serial-id serial-ID]
„
dap-num — Number of a Distributed MAP for which to display
configuration settings.
„
serial-id serial-ID — MAP access point serial ID.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Table 60 Output of display dap connection
Field Description
DAP Connection ID you assigned to the Distributed MAP.
If the connection is configured on another WX switch, this
field contains a hyphen ( - ).
Serial Id Serial ID of the Distributed MAP.
DAP IP Address IP address assigned by DHCP to the Distributed MAP.
WX IP Address System IP address of the WX switch on which the MAP has
an active connection. This is the switch that the MAP used
for booting and configuration and is using for data transfer.