3Com Wireless LAN WX1200 - Manual (Page 274)

274 C HAPTER 10: N ETWORK D OMAIN C OMMANDS
clear
network-domain Clears all Network Domain configuration and information from a WX
switch, regardless of whether the WX switch is a seed or a member of a
Network Domain.
Syntax — clear network-domain
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Examples — This command has no effect if the WX switch is not
configured as part of a Network Domain.
To clear a Network Domain from a WX switch within the domain, type
the following command:
WX1200# clear network-domain
This will clear all network-domain configuration. Would you
like to continue? (y/n) [n] y
success: change accepted.
See Also
„
set network-domain mode member seed-ip on page 280
„
set network-domain peer on page 281
„
set network-domain mode seed domain-name on page 282
clear network-domain peer on page 276
clear network-domain seed-ip on page 277
display network-domain on page 278
Table 47 Network Domain Commands by Usage (continued)
Type Command