Set mobility-domain mode seed domain-name – 3Com Wireless LAN WX1200 User Manual
Page 271
set mobility-domain mode seed domain-name
271
set
mobility-domain
mode seed
domain-name
Creates a Mobility Domain by setting the current WX switch as the seed
device and naming the Mobility Domain.
Syntax —
set mobility-domain mode seed domain-name
mob-domain-name
mob-domain-name
— Name of the Mobility Domain. Specify between
1 and 16 characters with no spaces.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Before you use this command, the current WX switch must
have its IP address set with the set system ip-address command. After
you enter this command, all Mobility Domain traffic is sent and received
from the specified IP address.
You must explicitly configure only one WX switch per domain as the
seed. All other WX switches in the domain receive their Mobility Domain
information from the seed.
Examples — The following command creates a Mobility Domain named
Pleasanton with the current WX switch as the seed:
WX4400# set mobility-domain mode seed domain-name Pleasanton
mode is: seed
domain name is: Pleasanton
See Also
clear mobility-domain member on page 266